Mixing Tool Housing; Mixing Tool; Maintenance; Blade - Robot Coupe MP 350 Turbo Manual De Instrucciones

• MIXING TOOL HOUSING

Never immerse the mixing tool housing
in water or put it in the dishwasher.
Instead, clean it with a slightly damp
cloth.

• MIXING TOOL

The mixing tool can be washed either by
hand or in the dishwasher. You can also
clean it with a slightly damp cloth.

MAINTENANCE

• BLADE

Over time the blades will become worn and will
need to be replaced. The washer and seals should
also be replaced at this time. A blade service kit is
available.

• TUBE SEAL

In order to maintain a watertight seal between the
tube and bell, inspect the seal for wear and replace
it if necessary.

• SEAL RING

The seal ring can be lubricated using a suitable
food grade grease. In order to maintain a watertight
seal, check the seal ring for wear and replace it if
necessary.

• WHISKS

The performance of the whisks depends on the
condition of the wires. The metal wires may become
worn over time. In order to ensure optimum
performance, they will need to be replaced. Do not
use a defective or damaged whisk!

• POWER CORD:

For your safety, make sure the power cord is
always in good condition. The cord is subjected to
considerable wear and tear, and must be replaced if
it is damaged in any way (cuts, burns, etc.).
Procedure for replacing the power cord:
1) Use the dismantling tool supplied with the new
replacement cord.
2) Press the push button (see photo) and pull on the
cord without releasing the dismantling tool.
Installing the new cord:
Turn to page 6
1
2

• CARTRIDGE

You need to change the cartridge :
- If liquid starts seeping into the foot
- If there is any play in the blade
1) Cartridge dismantling :
Position the knife dismantling tool
cartridge . Remove the cartridge from its place
B
by knocking on the knife dismantling tool
D
with a plastic mallet.
2) Cartridge mounting :
Direct the ears of car-
tridge
B
aligned with the groove
of the bell
cartridge with the hand
in the direction of arrow,
then clip on into the bell
thanks to the knife dis-
mantling tool.
on the
C
C
in order to be
. Push the
A
11