Minimum Heat Operation; Manual Auto Operation - Friedrich MW18Y3H Manual De Funcionamiento

MINIMUM HEAT OPERATION

• The room temperature can be maintained at 50°F by pressing the MIN. HEAT button
(Fig.6 b3) so as to prevent the room temperature from falling too far.
To use MINIMUM HEAT OPERATION
Press the MIN. HEAT button (Fig.6 b3)
The OPERATION indicator lamp (green) (Fig. 3 a5) will go out, and the ECONOMY
indicator lamp (green) (Fig. 3 a7) will light.
To stop MINIMUM HEAT OPERATION
Press the START/STOP button (Fig.6 b8)
Then the OPERATION stops and the ECONOMY indicator lamp (green) (Fig. 3 a7) will
go out.
About the MINIMUM HEAT OPERATION
• The Heating mode will not operate if the room temperature is high enough.

MANUAL AUTO OPERATION

Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 a2) on the main unit
control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 a2) once again.
(Controls are located inside the intake grille)
9315345288_OM.indb 12 9315345288_OM.indb 12
● Indicator Lamp
OPERATION
TIMER
ECONOMY
: Lighting : OFF
While MINIMUM HEAT OPERATION
is in progress, only Airflow Direction
Set can be used.
● When the air conditioner is operated
with the controls on the Main Unit, it will
operate under the same mode as the
AUTO mode selected on the Remote
Controller (see page 7).
● The fan speed selected will be "AUTO"
and the thermostat setting will be stand-
ard.(76 °F )
En-12
2/24/2010 1:36:25 PM 2/24/2010 1:36:25 PM