Control Panel Operation - Friedrich SS08 Manual De Instalación Y Operación

Let's check out how to control your air conditioner. On the control panel, just above the POWER , is a liquid crystal display (LCD). All of the control panel function
buttons and mode icons can be viewed in Figure 8.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch
will automatically dim to 20% intensity after 15 seconds of inactivity. The remote control can also be used to turn power ON / OFF (See Remote Control).
Display
inactivity, the display dims to 20% intensity. After an additional 120 seconds, the display switches off. Touching any button automatically changes the display
to full brightness.
There are three control push buttons on each side of the display.
Figure 8
SYSTEM FAN MODE
Cycles between Sets fan to either:
AUTO, HEAT, - Cycle automatically
COOL, or FAN - Run continuously
ONLY
(if equipped)
SYSTEM
FAN
MODE
FAN
AUTO SPEED
SPEED
AUTO
Automatically switches
between cool & heat
FAN SPEED
Selected fan speed
All manuals and user guides at all-guides.com

Control Panel Operation

FAN SPEED TEMPERATURE
Increment UP
Sets fan speed:
LOW, MED,
TEMPERATURE:
HIGH or AUTO
Increment DOWN
(if equipped)
F
SET POINT
COOL HEAT FAN
ONLY
AUTO
AUTO FAN
CONTINUOUS
AUTO SPEED
AUTO SPEED
Automatically Check / Clean
selects best fan
cooling speed
TIMER / SCHEDULE
Turns ON or OFF
TIMER
SCHEDULE
CONTROL
LOCKED
F
C
AM
PM
ON OFF
SET POINT
SCHEDULE
ROOM TEMP
CHECK $MART
FILTER
FILTER
$MART OPERATING
(if equipped)
ON / OFF
IR WINDOW :
Do not block Turns unit on/off
WI-FI
OPERATING
(if equipped)
WAIT
2 DIGIT DISPLAY
Shows Setting for:
- Set Point (Temperature)
- Room Temperature
- Clock (AM/PM)
SCHEDULE ON
TIMER ON
9