How To Operate Your Friedrich Room Air Conditioner; To Start Unit; Moneysaver ® Feature; To Set Mode Of Operation - Friedrich QuietMaster Electronic SS08R Guia De Funcionamiento

How to operate your Friedrich room air conditioner

DISPLAY
13

To start unit

1 If your air conditioner is installed and plugged into
a proper receptacle, it is ready to go. Touch ON/OFF
button once. The unit will automatically be in COOL
mode with the temperature set at 75°F (24°C) and the
fan speed at F1, the sleep setting. There is a 3-minute
delay before the compressor will turn on. (See next
page, "Automatic Component Protection.")
2 Should the FILTER ALERT light turn on when you
first turn on the unit, touch FILTER ALERT to turn
off the light.
FILTER ALERT light will come on after 250 hours of
use. (See page 7 for filter cleaning instructions.) Touch
FILTER ALERT to reset.

To set mode of operation

3 When you first turn on the unit, it will be in the COOL
mode (light on), with constant fan.
4
1
3
6
11
9
4
Touch MoneySaver
MoneySaver feature.
®
MoneySaver is a feature that cycles the fan with the
®
compressor so that the fan does not run all the time.
This saves energy and improves dehumidification.
MoneySaver will also run to test the temperature if
®
the off cycle is too long. Or you may prefer constant
fan for more air movement. To return to constant fan,
touch COOL.
5 Touch FAN ONLY (light on) if you want only the
fan to run. You may want to use this feature in
conjunction with the FRESH AIR / EXHAUST
lever to bring outside air into a room, or to exhaust
stale air. (See page 7, "Fresh Air and Exhaust
Control" for more information.)
12
2
4
5
8
7
10
15
14
Figure 2
(light on) to activate the
®