Troy-Bilt Super Bronco Manual Del Propietário página 28

Changing the Deck Belt
WARNING!
ignition key before removing the cutting blade(s) for
sharpening or replacement. Protect your hands by
using heavy gloves when grasping blades and
pulleys.
WARNING!
specially designed to engage and disengage safely.
A substitute (non-OEM) V-belt can be dangerous by
not disengaging completely. For a proper working
machine, use factory approved belts.
All belts on your tractor are subject to wear and should be
replaced if any signs of wear are present . To change or replace
the deck belt on your tractor, proceed as follows:
1. Remove the deck as instructed on page 24.
2. Remove the belt guards by removing the hex screws that
fasten them to the deck. See Figure 7-7.
Belt Guards
3. Carefully remove the deck belt from around the three
spindle pulleys and the two deck idler pulleys.
4. To place the new belt begin by routing the belt around the
two outer spindle pulleys, then around the front spindle
pulley as shown in Figure 7-8.
28 S 7— S
ection ervice
Shut the engine off and remove
The V-belts found on your tractor are
Hex Screws
Deck Idler Pulley
Figure 7-7
Deck Idler
Pulleys
Outer Spindle
Figure 7-8
5. Then route the belt around the two deck idler pulleys as
show in Figure 7-8.
6. Remount the belt guards removed earlier
7. Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
8. Pull the right side of the belt and place the narrow V side of
the belt into the PTO pulley. See Figure 7-9.
Figure 7-9
9. While holding the belt and pulley together, rotate the
pulley to the left (See Figure 7-9). Continue holding and
rotating the pulley and belt until the belt is fully rolled into
the PTO pulley.
10. Reinstall the belt guard in the notch of the PTO clutch. See
Figure 7-1.
CAUTION:
Failure to reinstall the belt keeper rod
may result in serious damage to your tractor's PTO
system.
Front Spindle
Pulley
Pulleys
PTO Belt
Rotate
Pulley