Doro Secure 347 Manual Del Usuario página 17

When the alarm button is deployed each speed dial number
(M1-M4) will be called in succession, and the recipient will hear
your pre-recorded alarm message. Therefore the most important
number should be programmed in the M1 position. If the recipient
presses a conversation can be conducted via speaker phone. If
#
the recipient does not follow the alarm instructions to press either
or , the call to each number will last for 60 seconds before
* #
the telephone hangs up and calls the next number on the list.
This procedure is repeated until the call is answered and accepted,
however there is a maximum limit of 14 times per number.
Alarm instructions
On hearing your alarm message the recipient can make the
following choices:
Press to speak to you via the speakerphone and temporarily
#
disable the alarm.
Conversation between you and the receiver can now be made in
the speaker phone. After 3 minutes another warning tone will
be heard. Press
minutes or press
to other numbers. If the receiver doesn't press
still active and the next number in the sequence will be called.
Press to deactivate the alarm and end the dialling to other
*
numbers.
If a call is unanswered or the alarm fails to be cancelled by the
recipient within 60 seconds a new dialling begins to your next
emergency number. (This is useful if an answer machine picks up
the call).
English
again to extend talking time by another 3
#
to deactivate the alarm and end the dialling
*
6
the alarm is
*