HOW TO USE
Operating the dryer
1
Lint Filter
2
3
4
5
6
If the lint fi lter has not already been cleaned, lift out the fi lter and remove the lint from the
last load. This will help ensure the fastest and most effi cient drying performance. Make sure
to reinstall the fi lter, pressing down until it clicks fi rmly into place. The dryer will not operate
without the lint fi lter in place.
Load the dryer with the wet laundry from the washer. If the load is extra large, you may need to
divide it into smaller loads for proper performance and fabric care.
Press the POWER button to turn on the dryer. The cycle LEDs will illuminate and a signal will
Turn the cycle selector knob either direction until the LED for the desired cycle is on. The preset
temperature, dry level, and option settings for that cycle will be shown. Refer to the Cycle
Guide. No special settings are necessary to take advantage of your hybrid dryer's energy saving
capabilities. However, some cycles and settings will save more energy than others. Default
settings for the selected cycle can now be changed if desired. This can be done using the cycle
NOTE
Not all options or modifiers are available on all cycles. A different chime will sound and the LED
will not come on if the selection is not allowed.
Press the START/PAUSE button to begin the cycle. The cycle can be paused at any time either by
minutes, the dryer will shut off and the cycle settings will be lost.
When the cycle is finished, the chime will sound if it is set. Remove your clothing from the dryer
immediately to reduce wrinkling. If WRINKLE CARE is selected, the dryer will tumble briefly every
few minutes to help prevent wrinkles from setting in the clothes.
31
HOW TO USE