Installation Location Requirements; Clearances - LG DLHX4072 Serie Manual Del Usuario

Installation location requirements

WARNING
manual before installing and using your dryer. Detailed instructions concerning electrical connections, gas connections, and exhaust
requirements are provided on the following pages.
must be exhausted to the outdoors. See Venting the dryer.
side of the dryer. See
shut off at the end of an automatic cycle. This can result in longer drying times. The dryer must not be installed or stored in an area where it
will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages,
closets, mobile homes or sleeping quarters. Contact your local building inspector.
NOTE
Extended Dryer Feet Kit. Clothes may not tumble properly, and automatic sensor cycles may not operate correctly if dryer is not level.

Clearances

14" max.*
(35.6 cm)
18" min.*
(45.7 cm)
1"* 30" 5"** 1"*
(2.5 cm) (76.1 cm) (12.7 cm) (2.5 cm)
INSTALLATION SPACING FOR RECESSED AREA OR CLOSET INSTALLATION
the sides and rear. Recommended spacing should be considered for the following reasons:
and servicing.
moldings.
NOTE
other. Too much vibration, it could cause them to make noise or touch each other causing paint damage and making even more
noise.
.
14" max.*
(35.6 cm)
48 in. 2*
18" min.* 2
(310 cm )
(45.7 cm)
24 in. 2*
(155 cm 2 )
30" 5"**
(76.1 cm) (12.7 cm)
INSTALLATION INSTRUCTIONS
It is important that you review this entire
be considered.
No other fuel-burning appliance can be installed in the same
closet as a dryer.
3" *
(7.6 cm)
0"
(0 cm)
39"
(99.1 cm)
*
3"
(7.6 cm)
1" 27" 1"
(2.5 cm) (68.6cm) (2.5 cm)
to reduce noise transfer.
For closet installation, with a door, minimum ventilation openings
in the top and bottom of the door are required. Louvered doors
with equivalent ventilation openings are acceptable.
15
1" 27" 1"
(2.5 cm) (68.6 cm) (2.5 cm)