Radio Controls Deletion Procedure; Automated System Test - Genius BRAIN 15 Instrucciones Para El Uso

cating memory storage executed, and then resumes
flashing for 5 sec., during which other radio controls can
be memory stored, and then goes OFF.

8.3. Radio controls deletion procedure

To delete ALL the input radio control codes, press push-button
LOGIC (SW3) or SPEED (SW2) and, while holding it down, also
press push-button SETUP (SW1) for 10 sec.
1. The LED relating to the pressed push-button flashes
for the first 5 sec, and then flashes more quickly for
the next 5 sec.
2. Both LEDs light up on steady beam for 2 sec and then
go OFF (deletion completed).
3. Release both push-buttons.
This operation is NOT reversible. All codes of radio con-
trols stored as OPEN A and OPEN B will be deleted.
9. BATTERY KIT (OPZIONAL)
The buffer battery kit was built for insertion inside the control
board support.
This support (Fig.4 ref. a) was pre-moulded to permit the
battery housing to be opened.
1. Remove the board support material covering the bat-
tery housing, cutting the material connections along
the perimeter.
2. Insert the battery in the housing you have just created,
and secure it on the anchoring supports (Fig. 5).
3. To correctly fasten and connect the kit to the control
unit, consult the instructions enclosed with the battery
kit.

10. AUTOMATED SYSTEM TEST

When you have finished programming, check if the system is
operating correctly. In particular, check if the safety devices
are operating correctly.
Fig. 4
Fig. 5
BRAIN 15 Pagina 1
Guide for the installer