Ground Connection - Mosa GE 7000 Manual De Uso

© MOSA REV.2-06/10
BATTERY WITHOUT MAINTENANCE
Connect the cable + (positive)
to the pole + (positive) of the
battery (after having
away the protection), by
properly tightening the clamp.
Check the state of the battery
from the colour of the warning
light which is in the upper part.
- Green colour: battery OK
- Black colour: battery to be recharged
- White colour: battery to be replaced
DO NOT OPEN THE BATTERY.
LUBRICANT
Check the level of the engine oil using the
ASTINA LIVELLO
(appropriate oil dipstick: the level should
OLIO
MAX
LIVELLO
be between the minimum and maximum
OPERATIVO
MIN
marks.
lf necessary, add more oil through the appropriate
inlet
OIL RECOMMENDED
MOSA advises to choose AGIP for the type of oil.
Please keep to the label put on the engine for the
recommended products.
+ NOTE: before starting and switching off, see
instructions in the engine owner's manual he-
rewith attached.
SETTING-UP THE UNIT (GASOLINE ENGINES)
FUEL
Check the level of fuel in the tank and, if necessary,
add unleaded gasoline.
taken
For further information regarding the fuel which has
to be used, see instructions in the engine owner's
manual herewith attached.
If during the filling of the tank some
gasoline is accidentally spilled around
the engine chassis, clean it immediately
before starting up the engine.
ENGINE WITH OIL ALERT DEVICE
The OIL ALERT device will stop the engine in case
of no oil or insufficient amount of oil in the engine.
In case one tries to start the engine with oil below the
minimum level, the warning light (when assembled)
will light and the device will not allow starting.
CLEANING OF DRY AIR FILTER
Check that the dry air filter is correctly installed and
that there are no leaks around the filter which could
lead to infiltrations of non-filtered air to the inside of
the motor.

GROUND CONNECTION

+ lt is obligatory to connect the ground connec-
tion point (12) by means of a sure efficient cable
(please follow the installation local rules and/
or regulations in force) in order to integrate or
ensure the working of various electric protec-
tion devices referring to the several distribution
systems TN.
The unit can be started only when the above ope-
rations have been correctly performed.
M
25