Recommended Oil; Ground Connection; Air Filter - Mosa GE 4000 LDS/GS Manual De Uso Y Mantenimiento

REV.0-05/04
LUBRICANT
Please refer to the motor operating manual for the
recommended viscosity.
Oil filling and level ispections must be carried out
with the engine on a flat surface:
1. Remove oil filler cap (24);
2. Pour the oil in and reassemble oil cap;
3. Check the oil level using the dipstick (23); the oil
level must be comprised between the minimum
and maximum indicators.

RECOMMENDED OIL

MOSA recommends selecting AGIP engine oil.
Refer to the label on the motor for the recommended
products.
ATTENTION
!
It is dangerous to supply too much lube oil to the
engine because a sudden increase in engine rpm
could be caused by its combustion.

AIR FILTER

Check that the dry air filter is correctly installed and
that there are no leaks around the filter which could
lead to infiltrations of non-filtered air to the inside
of the motor.
SET-UP FOR OPERATION
FUEL
ATTENTION
!
Do not smoke or use open flames during
refuelling operations, in order to avoid
explosions or fire hazards.
Fuel fumes are highly toxic; carry out
operations outdoors only, or in a well-
ventilated environment.
Avoid accidentally spilling fuel. Clean any
eventual leaks before starting up motor.
Fill the tank with diesel for automobiles.
For further details on the type of diesel to use, see
the motor operating manual supplied.
Do not fill the tank completely; leave a space of
approx. 10 mm between the fuel level and the wall
of the tank to allow for expansion.
In rigid environmental temperature conditions (-10°
C), use special winterized diesel fuels or specific
additives in order to avoid the formation of paraffin.

GROUND CONNECTION

Proper grounding is obligatory for all models featu-
ring a ground fault interruptor [G.F.I.] switch. This
safety device functions correctly only if the machine
is grounded.
+ Use a good quality grounding cable and connect
it to the machine's ground terminal (12). Abide by
local norms and/or laws concerning safety and
electrical installations.
When these operations have been carried out, the
unit can be started up for operation.
GE 4000 LDS/GS
M
25