Connecting The Receiver To The Mains Voltage; Connecting The Audio Outputs Of The Dsrtetrad Receiver; Connecting The Receiver To A Balanced Input; Connecting The Receiver To A Speaker - Harman AKG DMSTetrad Instrucciones De Uso

Installation and Connection
Connecting the receiver to the mains
voltage
Connecting the audio outputs of the
DSRTetrad receiver
12
1) Check that the AC mains voltage stated on the included power supply is identical to the AC
mains voltage available where you will use your system. Using the power supply with a
different AC voltage may cause irreparable damage to the unit.
2) Plug the feeder cable of the included power supply into the DC IN socket (9) (12 V, 0.5 A)
of the receiver.
3) Connect the power supply to a power outlet. Ensure that you are using the correct adapter
for the country you are in!
4) Use the strain relief to avoid pulling out the mains cable accidentally.

Connecting the receiver to a balanced input

1) Turn down the level of the audio output on this channel (12) with the VOLUME
potentiometer (2).
2) Use an XLR cable to connect the BALANCED output (12) of the required channel on the
back of the receiver to the balanced microphone input (XLR socket) on the mixer or
amplifier.

Connecting the receiver to a speaker

Use an XLR cable to connect the sum output (14) of all four channels on the back of the receiver
to an active speaker.
DMSTetrad