Installation And Connection; Positioning The Receiver; Rack Assembly; Connecting The Receiver To Power - Harman AKG DMS70 Quattro Modo De Empleo

3 Installation and Connection

Positioning the receiver

Rack assembly

Connecting the receiver to power

DMS70 Quattro
1) Always position the receiver near to where the action is taking place (e.g. stage).
2) Check that you can see the receiver from where you will be using the transmitter.
Assembling the DSR70 Quattro in a 19" rack
Assemble the DSR70 Quattro receiver in your
19" rack with the supplied rack brackets, fixing
screws and washers - these are screwed into
the side of the receiver.
1) Unscrew the fixing screws of each of the
two side walls.
2) Secure the rack brackets to the receiver
using the fixing screws.
3) Secure the receiver in the rack.
4) Rotate both antennas (7) up to the
"normal position" (see image on the cover
page) to achieve optimum transmission
and reception performance.
Use of two receivers in one rack
1) Fit both receivers in the rack with one unit
of space between them.
2) Rotate both antennas (7) up to the "normal position" (see image on the cover page).
1) Check that the AC mains voltage stated on the included power supply is identical to the
AC mains voltage available where you will use your system. Using the power supply with
a different AC voltage may wreck the unit.
2) Plug the feeder cable of the included power supply into the 12 V, 0.5 A, DC IN socket
(11) on the receiver.
3) Connect the AC adapter to a power outlet. Ensure that you are using the correct adapter
for the country you are in.
Installation and Connection
Figure 6: Fitting the DSR70 in a 19" rack
11