Daylight And Motion-Sensing Functions; Test Function; Setting Offset; 100 H Burn-In - Osram DALIeco Control Manual De Instrucciones

DALIeco Control
5.8 Daylight and motion-sensing functions
The daylight and motion-sensing functions can be set for:
- jointly for directly connected sensors (PROG mode
- individually for directly connected sensors (sensor select
Daylight functions
Push-button [ON] • Fully automatic daylight control active
ON
Semi
Push-button • Automatic switch-off with too much daylight
Auto
[Semi Auto] • Manual switch-on
OFF
Push-button [OFF] • Daylight control switched off
Motion-sensing functions
Push-button [ON] • Motion-detection active
ON
• Automatic change to "STANDBY" or "OFF" after overrun
Semi
Push-button
Auto
time has expired
[Semi Auto]
• Manual switch-on
OFF
Push-button [OFF] • Motion-detection switched off

5.9 Test function

The detection range of the sensor can be checked using the test function.
1. Press push-button [test] (SP) to switch on the test function.
test Switch off delay
2. Press push-button [PROG] (SP) to exit programming mode
1 sec 30 sec 1 min
and start the test.
3. Enter the detection area:
- with detection 100% ON,
- without detection after 1 sec. back to 1% ON.
4. If necessary, adjust the detection range by setting the screens
on the sensor and repeat steps 3 and 4 as often as necessary.
5. After completing the test, either wait 60 seconds or press the
push-button [ON/OFF] or [CH-1/CH-2] (SP) to switch off the
test function (return to normal function).
29
5.1)
5.12)

5.10 Setting offset

Setting the OFFSET (=distance from CH-2 to CH-1) of a specifi c function mode.
1. Press push-button [Offset] (SP).
100 h
Offset
Burn-in PC modes
ON ON
1 2
OFF OFF
2. Offset is set using the push-button rocker [CH-2]:
- LP = Coarse setting
CH-1 CH-2
- SP = Fine setting
Auto
The offset of Ch-2 can be:
setup
- min. = value of CH-1
Manual
- max. = 100 % brightness
setup
3. Press push-button [Offset] (SP) to save the setting.
i Please note:
Offset adjustment is only possible outside of programming mode.

5.11 100 h Burn-in

When using fl uorescent lamps, stable operation and maximum lifespan are only assured after a
burn-in phase (100 h at 100%). The automatic functions are switched off during burn-in, all lamps
in the system illuminate at 100%.
LEDs on all connected sensors light up red continuously.
1. During commissioning or before regular use of the system
100 h
Offset
Burn-in PC modes
press the push-button [100 h Burn-in ON/OFF] (SP) to start
ON ON
1 2
OFF OFF
the process.
2. Press push-button [100 h Burn-in ON/OFF] again (SP) to end
the process prematurely.
Each function call-up restarts the 100 h time period.

5.12 Sensor select

1. Press push-button [Sensor select] (LP) to select a sensor
ON Sensor (LED on selected sensor fl ashes orange).
select
OFF
Periodically changing LED display on the sensor:
- Orange = Sensor selected
- Red = Motion detection active
- Green = Daylight function active
2. Implementing sensor settings
3. If several sensors are in the system, press the push-button
[Sensor select] (SP) again to select the next sensor.
4. Press push-button [Sensor select] (LP) to save sensor
settings or press push-button [PROG] (SP).
GB
5.8.