DALIeco Control
5.13 PC modes
Confi gurations created with the aid of the DALIeco PC software and saved via USB in the PC1
or PC2 memory can be transmitted and sent to a control unit by pressing the PC1 or PC2 push-
button.
100 h
1.
Activate programming mode by pressing and holding the
Burn-in
Offset
PC modes
ON
ON
[Prog] push-button
1
2
OFF
OFF
2.
Press [PC1] or [PC2] to start the transmission process
3.
The complete, successful transmission of the confi gurations is
confi rmed when the light fl ashes.
See the corresponding instructions for details about the PC
software functions.
5.14 Macro recorder
If several control units have an identical confi guration, the button sequences of the master
remote during the commissioning process can be recorded with a macro recorder and then
transferred to other control units.
1.
Activate programming mode by pressing and holding the
[Prog] push-button
2.
Start recording by pressing and holding the [Rec] push-button
Macro Recorder
(light increases to 100% and the red LED of the "Sensor
select" push-button on the remote control indicates the start
of recording)
3.
Carry out normal programming (see section 5)
4.
Terminate recording with the [Stop] push-button (red LED of the
"Sensor select" push-button on the remote control goes out)
5.
Play back the confi guration with the [Play] push-button and
transfer to another control unit via IR telegrams.
Important note:
i
The individual confi guration of single sensors via "Sensor select" cannot be recorded
and transferred with the macro recorder. Recording is automatically terminated when
programming mode is exited.
6
Creation of individual confi gurations with the DALIeco
PC Software
Individual function profi les and parameter settings can be created with the DALIeco PC Software,
stored via USB on the Master Remote, then transferred via IR to the control unit.
Details and software can be downloaded on the Internet at: www.osram.com/dalieco
30
7
System operation using User Remote
When pressing the User Remote push-button always point to the relevant sensor.
7.1 Scene push-buttons [1] to [4]
•
Calling up scene: Selection of the saved light scene by
push-button (SP).
•
Saving scene: a manually changed lighting intensity using
[CH-1] and/or [CH-2] can be saved to the specific scene
button by pressing the push-button (LP) (system flashes in
confirmation).
•
Blocking or releasing scene saving:
1. - Simultaneously press push-buttons [Holiday]+[CH-2
(VLP) (LED flashes red).
2. - Press push-button [1] (SP) to block scene saving
(LED lights up red for three seconds)
- Press push-button [2] (SP) to release scene saving
(LED lights up green for three seconds).
7.2 Push-button [Holiday]
Temporary deactivation of motion-detecting by pressing a push-
button (SP), sensor LED lights up red continuously.
Reactivation using push-buttons [ON/OFF], scene push-buttons
[1] to [4] and [CH-1]/[CH-2] is possible.
7.3 Push-button [Resume]
Restarting of the automatic light control function by push-button
(SP). For function modes without light control this push-button has
no function.
7
GB
]