Replacing Parts; Sweep Hose; Debris Bag; Swivels - Hayward VIPER 5500 Guia Del Usuario

Some parts will wear with normal use. To insure the high
quality performance, insist on Genuine Hayward
replacement parts (using non-Hayward replacement
parts will Void the Viper Cleaner's Warranty).
The following parts are user replaceable and subject to
normal wear and tear.
1. Sweep Hose: If a hole forms in the Sweep Hose, it
should be replaced. Unscrew the mender nut from the
hose and pull the Sweep Hose off the Cleaner Connector.
Attach a new Sweep Hose to the Cleaner Connector.
(Replacement Part Number: AX6000RSHA)
2. Debris Bag: The Debris Bag should be replaced if it
is torn.
(Replacement Part Number: AX5500BFA)
3. Swivels: If a swivel ceases to turn easily or leaks while
the cleaner is running, it should be replaced.
(3-Pack Replacement Part Number: AX5000SA)

Storing the Viper Cleaner

1. Turn the Booster Pump OFF and set the timer so the
Booster Pump will not turn on while the Viper cleaner is
out of the pool (Never operate the Booster Pump without
the cleaner connected).
2. Disconnect Wall Quick Connect from the Universal Wall
Fitting. The Universal Wall Fitting may be left in place.
3. The cleaner is constructed of the finest materials
available, however we recommend that when the Viper
cleaner is removed from the pool, it should be stored flat
on its wheels in a shaded area to protect the unit from
excessive exposure to ultraviolet solar rays.
4. Store the Sweep and Pressure Hoses straight and flat,
not coiled. If possible, store the hoses in the shade.
Use Only Genuine Hayward Replacement Parts.

Replacing Parts

Winterizing the Cleaner
When closing your pool for the winter completely drain the
water from the Viper Cleaner (by slowly rotating it in all
directions) and Hoses. Store the Viper Cleaner indoors to
prevent freezing the inner mechanisms.

Periodic Freezing Conditions

If you are in an area subject to periodic freezing conditions, but
pool equipment is kept in operation, it is very important that
the filtration system and Viper cleaner be in operation during
times when hard freezing occurs (normally between 3AM and
7AM). Running the Viper cleaner at this time will insure against
damaging the Cleaner and may prevent freezing of pool water.
15