Sizing Pressure Hose; Preparing Hose; Measuring Pressure Hose - Hayward VIPER 5500 Guia Del Usuario

The 34+ foot long Pressure Hose carries water from the
Universal Wall Fitting to the cleaner. It comes assembled
as follows:
• Cleaner Connector, 1 foot hose with Jetted Swivel
(Note: Jet is on "bottom" of hose, aligned with
Sweep Hose attachment)
• 10 foot hose, with 3 floats
• Swivel
• 10 foot hose, with 3 floats
• Swivel
• 10 foot hose, with 3 floats
• Wall Quick Connect with Flow Regulator and Universal
Wall Fitting
Float Spacing: There are three, ten-foot hoses, each with
3 floats. A float should be placed 18 inches from each end
and one float in the middle, 5 feet from either end.

Preparing Hose

Stretch hoses out as straight as possible, preferably in the
sun, to allow them to relax and straighten.
Note: Bent hoses will cause tangling and impede proper
performance of the Viper cleaner.
Measuring Pressure Hose Specification
Cleaner performance depends on a properly sized
pressure hose.
J
Jetted Swivel
C
Cleaner Connector
Last Swivel
Use Only Genuine Hayward Replacement Parts.
Note: End of hose to be cut if necessary

Sizing Pressure Hose

L
Wall Quick Connect
7