Mender Nut Connections - Hayward VIPER 5500 Guia Del Usuario

IMPORTANT: Read Carefully
1 . Insert the Wall Quick Connect into the Universal Wall Fitting.
2 . Hold the other end of the hose and walk around the pool to
the farthest point from the dedicated return line in the pool
wall (see diagrams below).
3 . a) If the hose does not reach the farthest point along your
pool wall (from the dedicated return line) then you must
purchase a 10 foot pressure hose extension (AX5500HE)
b) If the hose reaches past the farthest point along your pool
wall (from the dedicated return line) then cut off the portion
of the hose that extends past the pool wall. We recommend
using Anvil-type shears (but a Utility Knife can be used)
Double-check your measurement.
c) If you need to remove one complete section of hose.
(10 ft.) remove the hose section farthest from the
Universal Wall Fitting.
R e c t a n g u l a r-Shaped Po o l
Farthest Point
Kidney-Shaped Po o l
Farthest Point
Angle-Shaped Po o l
Universal Wall Fitting
(Dedicated Line)
8
Universal Wall Fitting
(Dedicated Line)
Universal Wall Fitting
(Dedicated Line)
Farthest Point
4. Dip the Jetted Swivel (part J) and the cut end of the hose
in soapy water. Attach the cut end of the hose to the
Jetted Swivel using the mender nut.
5. Attach the Setup Pressure Gauge (Part T) to the Cleaner
Connector (Part C).

Mender Nut Connections

Note: It is easier to install the swivels when the hose and
swivels are wet.
1. Slide Mender Nut on to end of the swivel with small end
of nut towards pressure hose.
2. Insert end of swivel into Pressure Hose so end of Hose is
over reduced diameter of swivel.
3. Slide Mender Nut back over Pressure Hose and
tighten well.
Mender Nut Connections
Hose
Mender Nut
Use Only Genuine Hayward Replacement Parts.
Swivel