Troubleshooting - Dometic ROLLERBLIND CHAIN Instrucciones De Montaje Y De Uso

Rollerblind Chain
Removing dust
➤ Dust the blind regularly with a dust rag, dust glove or a vacuum cleaner with a
brush attachment. Blow excess dust off of your fabric using a can of compressed
air or a hair dryer on a cool setting.
➤ Fully deploy the blind to clean the fabric.
➤ Fully stow the blind to clean around side tracks or guide wires.
Spot cleaning
➤ Spot-clean with a soft white cloth, moistened with warm water. Add a mild deter-
gent if needed (non-abrasive and with no additives).
➤ Blot gently to avoid creasing or damaging the fabric. Always leave the blind
deployed to dry thoroughly.
Cleaning windows
➤ Always ensure the blinds are fully stowed before cleaning windows. This will
prevent spoiling the blind fabric by splatter or sprays of water or detergent.
9

Troubleshooting

Fault
Guide wire tension too low
Guide wire too short
Guide wire broken
Guide wire blind not running smoothly
Fabric rolls off sides of ends of roller
EN
Solution
➤ See chapter "Fitting the guide wire ver-
sions" on page 7.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Order replacement guide wire, see
spares leaflet at dometic.com.
➤ Check restraint position and recess
dimensions.
➤ Check if the guide wires are perpendicu-
lar to the roller and that the roller is hori-
zontal.
Troubleshooting
9