Bosch JS120 Instrucciones De Funcionamiento Y Seguridad página 9

accessories. Such preventive safety measures reduce the risk of starting the tool
accidentally.
Blade Installation and
Removal
ejector lever when there is no blade in
the blade clamp or when inserting the
blade.
BLADE INSTALLATION
Insert the saw blade (teeth in cutting
direction) into the slot in the blade
clamp until the blade ejector lever
rotates to the LEFT, indicating that the
clamp has engaged. (When inserting the
saw blade, the back of the blade must
rest in the groove of the guide roller
Fig. 2.)
BLADE EJECTION
The tool should be held so that the
blade is safely ejected. To remove the
saw blade, rotate the blade ejector
lever to the RIGHT to the center stop;
this releases and ejects the saw blade
(Fig. 3).
Blade Clamp Reset
There are two situations in which it is
necessary to reset the blade clamp:
RESET Type A: If the blade ejection
lever is rotated improperly, the "fingers"
within the clamp may slip into the blade
insert slot. To reset the clamp:
Step 1 – Using a a screwdriver, push
down on blade clamp fingers (as viewed
from the bottom of the jig saw), until
clamp can be rotated.
Step 2 – Rotate blade ejector lever to
the RIGHT until it locks into place.
The clamp is now ready for use.
RESET Type B: If the two fingers inside
the blade clamp accidentally get pushed
too far into the plunger, they will
prevent insertion of a blade. To bring
the fingers back to their correction
positions:
Step 1 – Turn the blade ejector lever to
the RIGHT (as viewed from the bottom
of the jig saw)
Disconnect battery pack from tool or place the switch in the locked or
off position before making any assembly, adjustments or changing
To prevent damage,
do not turn blade
Assembly
Step 2 – Continue the rotation unto
fingers will snap into the correct open
position.
The clamp is now ready for use.
BLADE
BLADE CLAMP IN OPEN POSITION
BLADE
BLADE CLAMP IN LOCKED POSITION
-9-
FINGERS
(As viewed from the bottom)
BLADE
(As viewed from the bottom)
FIG. 2
BLADE
CLAMP
LEVER
FIG. 3
BLADE
CLAMP
LEVER