Protection Against Deep Discharging - Bosch JS120 Instrucciones De Funcionamiento Y Seguridad

Ocultar thumbs Ver también para JS120:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Protection Against Deep
Discharging
The lithium ion battery is protected
against deep discharging by the
"Electronic Cell Protection (ECP)".
When the battery is empty, the machine
is switched off by means of a protective
circuit: The inserted tool no longer
rotates.
Battery Charge-control
Indication
The three green LEDs of the battery
charge-control indicator show the
charging status of the battery. (Fig. 1)
JA1010 Circle and Parallel
Cutting Guide
(Sold separately)
The JA1010 is used for fast and
accurate straight and circle cutting. It
includes the guide, two clamps (A) for
attaching it to the jig saw, and a center
pin (B) for guiding circle cuts. The
clamps and the centering pin can be
stored on the guide (Fig. 9).
One end of the clamp is used to attach
the guide's bar to jig saws that have
narrow tops on their footplate mounting
slots (C) and the other end is used to
attach the guide's bar to jig saws that
have wide tops on their footplate
mounting slots (D) (Fig. 10).
When possible, attach the bar to the jig
saw using both clamps for enhanced
grip and precision.
ATTACHING GUIDE TO JIG SAW
1.
Orient the blade clamp so that the
proper end is placed on the jig saw
foot from either side of the tool.
2.
Insert guide's bar through a clamp,
then through the slots provided in
foot,
with
orientated correctly for the intended
application, parallel cutting or circle
cutting. (If possible, place second
clamp on bar from opposite side of
jig saw.)
Operating Instructions
Operating Instructions
the
guide's
fence
The battery charge control indicator
only illuminates for 5 seconds after
start-up.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Flashing light 3 x green
When no LED lights up after switching
on, then the battery is defective and
must be replaced.
Fig. 9
C
3.
Place lock knob(s) on proper side of
clamp(s) and securely tighten lock
knob(s) on the clamp(s) (Fig. 11).
-14-
Capacity
2/3
1/3
<1/3
Reserve
Empty
A
B
Fig. 10
D

Publicidad

Tabla de contenido
loading

Tabla de contenido