Rowenta ES-180 Instrucciones De Uso página 15

086080AL AN FR IT ES POR NE SU
•
The two start-up and water temperature lights will come on (fig. 13).
•
The cup selection lights will flash.
•
Select the amount of coffee you wish for each cup by turning the water dosage selector (C4) to the right for a
strong espresso and to the left for a weaker one (fig. 6).
•
Press the 1-cup "
for C2 or C3 will remain on while the espresso is being extracted.
•
When the water has reached the correct temperature, the water temperature light will go out.
•
The espresso will flow into the cup(s) after a few moments and then stop automatically.
C. MANUAL CORRECTIONS TO OBTAIN THE DESIRED AMOUNT.
1 - THE AMOUNT OBTAINED IS INSUFFICIENT:
To increase the amount of coffee in your cup(s) immediately after the drip cycle stops and while the indicator light
of key C2 or C3 is flashing:press on the key selected once again (1 or 2 cups) until you have the amount desired.
2 - THE AMOUNT OBTAINED IS TOO MUCH:
To prevent overflow, it is possible to stop the drip cycle during operation by pressing on key C2 or C3 (the key
just selected).
•
Remove the cups.
D - CLEANING THE FILTER HOLDER.
•
Release the filter-holder by lightly pressing the "EJECT" button while turning the holder to the left and withdraw
it from the machine. Throw away the used coffee grounds by using the ejection system and pressing fully on the
"EJECT" button on the handle (fig. 3). Wash the filter-holder in running water, activating the "EJECT" button to
remove any coffee residue (also see para 8. B.For more thorough cleaning).
•
To make a fresh espresso, turn the C1 selector to the "
above process.
COMMENTS
It is normal for a slight noise to be heard from water or steam circulating each time the C1 control returns to "0"
and " " (steam heating). This is due to a special device removing pressure from all circuits.
The automatic water dosage selector does not permit correcting the amount of coffee during the drip cycle.
6. PREPARING THE STEAM.
The steam is used to froth up the milk (e.g. for cappuccinos and hot chocolate) and to heat the water (for tea and
other hot drinks).
•
Turn the C1 selector to the " " position (steam heating) (fig. 14). To obtain more steam, the temperature setting
should be higher than for coffee.
•
The two power on and water temperature lights will come on.
•
Place the liquid which is to be heated into a container. For better results, we recommend that the liquid to be
reheated or frothed up should be poured into a container will a small mouth (small jug, for example).
•
Dip the steam nozzle in the liquid.
•
When the water has reached the correct temperature, the water temperature light will go out. You can then turn
selector C1 to the " " (steam position) (fig. 15).
•
To obtain a good froth on the milk, agitate with circular movements and move up and down (fig.16).
The pump will operate intermittently. This is normal.
•
During the process, it is normal for the water temperature light to go on and off.
•
When the liquid is hot and/or frothy, stop the machine ("0"position).
IMPORTANT !
Once the steam has stopped, immediately clean the nozzle carefully with a damp sponge so that the residue
"does not stick" and then produce a little more steam in the open air to rinse out the inside.
18/09/02
" (C2) or 2-cup key" " (C3) according to the desired number of cups (fig. 7). The light
16:39 Page 15
" (coffee extraction) (fig. 5) and 1 seul mot repeat the