Warning Label Identification; Sander Specific Warnings - Ingersoll Rand CA-EU Serie Instrucciones

Lijadoras de correa angulares
Ocultar thumbs Ver también para CA-EU Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
Do not use this tool if actual free speed exceeds the
nameplate rpm.
Before mounting a sanding belt, after any tool
repair or whenever a Sander is issued for use, check
free speed of the tool with a tachometer to make
certain its actual speed at 90 psig (6.2 bar/620 kPa)
does not exceed rpm stamped or printed on the
nameplate. Sanders in use on the job must be
similarly checked at least once each shift.
Always use the recommended Ingersoll–Rand
Guard furnished with the Sander.
INSTALLING A SANDING BELT
When installing a new sanding belt, proceed as follows:
1. For 18" models, slide the Cover rearward toward the
handle of the Sander until it is free. It may require a
light rap on the front edge of the Cover to disengage it
from its locking points.
2.
Compress the Idler Wheel and slip the old belt off the
drive Sleeve. Release the pressure on the Idler Wheel
and remove the belt.
3.
Position a new belt on the Idler Wheel.

WARNING LABEL IDENTIFICATION

Always wear hearing
protection when operating
this tool.
Do not carry the tool by
the hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pressure.

SANDER SPECIFIC WARNINGS

ADJUSTMENTS
WARNING
WARNING
WARNING
Series CA120 Angle Belt Sanders have a free speed
of 12 000 rpm and a belt speed of 2 700 sfpm while
Series CA200 Angle Belt Sanders have a free speed
of 20 000 rpm and a belt speed of 4 500 sfpm, when
operated at 90 psig (6.2 bar/620 kPa) air pressure.
Operation at higher air pressure will result in
excessive speed.
Do not operate a Belt Sander with the Cover
removed.
4.
Compress the Idler Wheel with the belt and slip the
opposite end of the belt onto the Drive Sleeve around
the Spindle Cap. Release the pressure on the Idler
Wheel.
5.
For 18" models, align the Cover with the Guard and
slide it forward toward the Idler Wheel until it snaps
into position and stays there.
6.
Operate the Sander at low speed to determine if the
new Belt is tracking properly. If the Belt fails to track
properly, realign the Clevis by tightening or loosening
one or both of the Clevis Mounting Screws.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________

Publicidad

Tabla de contenido
loading

Tabla de contenido