Warning Label Identification; Sander Specific Warnings; Placing Tool In Service - Ingersoll Rand E5P Manual Del Usario

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
•
These Sanders will operate at the free speed
specified on the label if the air supply line
furnishes 90 psig (6.2 bar/620 kPa) air pressure at
the tool. Operation at higher air pressure will
result in excessive speed.
•
Use only a sanding pad, buffing wheel or polishing
bonnet with these tools. Do not use any grinding
wheel, bur or metal removing accessory with these
tools. Never use an accessory having a maximum
operating speed less than the free speed of the
Sander in which it is being used.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Model
E5C
E6C
E5P
E6P
H
Tested in accordance with PNEUROP PN8NTC1.2
♦ Tested in accordance with ISO8662–8

WARNING LABEL IDENTIFICATION

90 psig
(6.2bar/620 kPa)

SANDER SPECIFIC WARNINGS

PLACING TOOL IN SERVICE

FILTER
COMPRESSOR
(Dwg. TPD905–1)
Free
Speed
12,000
12,000
12,000
12,000
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
•
When using a pad having a shank, insert the shank
to full depth in the collet. When using a pad on a
threaded arbor, make certain the flange nut is
tightened securely. Check the tightness of the collet
nut or flange nut before operating a Sander to
make certain it will not loosen during operation.
SPECIFICATIONS
Pad Diameter
in mm
5 127
6 152
5 127
6 152
2
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
(Dwg. ATP27)
HSound Level
dB (A)
Pressure Power
81.6 –––
81.6 –––
81.6 –––
81.6 –––
WARNING
WARNING
♦Vibrations
Level
2
m/s
4.7
4.7
4.7
4.7