Publicidad
NOTE:
Do not wash the vehicle for 24 hours following installation of this product.
If this product requires cleaning after installation, wipe with a soft cloth or sponge with mild detergent and wipe thoroughly with a dry
cloth. Do not use gasoline, thinner, acid, alkaline or other solvent based products.
The recommended adhesive surface temperature range is 77 F - 104 F(25℃ - 40℃).
If the surface temperature is below 60 F(15℃), heat the double sided tape and bumper surface to a temperature of 77 F - 104 F (25℃ - 40℃).
This instruction shows only LH side. Please repeat the steps on RH side.
1
Remove the OE side sill spoiler .
※Please refer to the Subaru service manual for details .
2
Detergent
The figure shows the LH
Ft
Side sill spoiler
(3)
Publicidad
