Publicidad
NOTE:
Do not wash the vehicle for 24 hours following installation of this product.
If this product requires cleaning after installation, wipe with a soft cloth or sponge with mild detergent and wipe thoroughly with a dry
cloth. Do not use gasoline, thinner, acid, alkaline or other solvent based products.
The recommended adhesive surface temperature range is 77 F - 104 F(25℃ - 40℃).
If the surface temperature is below 60 F(15℃), heat the double sided tape and bumper surface to a temperature of 77 F - 104 F (25℃ - 40℃).
This instruction shows only LH side. Please repeat the steps on RH side.
1
2
Open the vehicle door and
position pattern B approximately
500mm from the side panel joint
and then bend pattern B as shown
in the image.
Note:For the RH side,bend
pattern B so that the small
tab also faces the rear of
the vehicle.
⑨pattern
Ａ
⑨pattern
Fr
Apply a piece of masking tape
above pattern A's small flap as
shown in the image.This piece of
masking tape will be used to
determine the vertical position
of the under spoiler.
Attach pattern A to the Mud Guard.
Ｂ
⑨pattern
Fr
Side Panel Joint
(3)
Apply a piece of
masking tape above
pattern B as shown
in the image.This
piece of masking
tape will be used
to determine the
vertical position
the under spoiler.
Ｂ
20in(500mm)
Publicidad
