Using The Clipper; Removing The Blade - BaByliss PRO X2 VOLARE FX811 Manual Del Usuario

AC OPERATION
You can use your clipper even when the battery capacity is low.
1. Make sure the power switch is off before connecting the adapter.
2. Connect the AC adapter in the same way as for charging. Plug
adapter into power outlet. The red charging light will come on.
3. Move the power switch to the ON position. The red charging
light will stay on for a second and then the unit will start.
4. If the clipper does not operate, charge the clipper for approxi‑
mately 1 minute.

USING THE CLIPPER

Slide the taper control up or down to adjust the
moving blade to the desired height. The blade is
adjustable in four (4) stages from 0.8 mm to 2.0
mm, in 0.4 mm steps without attachments. The
actual cut length may be longer than the set length.
Using the Comb Attachments
1. Select the desired comb attachment.
Trimming height is indicated on the outside
and sides of the attachments.
2. Set the taper control to 0.8 and
then mount the attachment to
the clipper.
3. To attach the comb, do not press
on the tab. You must press over
the number as shown. The tab is
only for comb removal.
8
Press here to attach.
Push up
here
to remove.
Removing the Attachment from the Clipper
1. Remove the attachment as illustrated.

Removing the Blade

1. Be sure to turn off the power before you
remove the blade.
2. Hold the clipper with the switch facing upward and push
the blade with your thumb while catching the blade in your
other hand.
9