BaByliss PRO X2 VOLARE FX811 Manual Del Usuario página 7

Lubrication
1. Apply a few drops of the oil to the space between the fixed
comb blade and moving cutter blade. Apply the oil to the clip‑
per before and after each use.
VERY IMPORTANT
Blades must be cleaned and oiled on a regular basis so they
will function properly. Failure to regularly clean and oil the
blades will void the warranty.
2. Set the taper control to 2.0 and then remount the blade on
the clipper.
About the Lithium‑Polymer Battery Pack
To ensure that the new battery reaches its full potential, the
battery should be drained to rapid flashing red LED after the first
use. This operation will only have to be performed once. The unit
should then be fully charged until blue LED appears.
Note: It may take 5‑10 charging cycles for the battery to reach
its full potential.
12
Removing the Built‑in Rechargeable Battery Pack
1. Discharge the battery pack completely before removing it.
2. Turn unit off and disconnect the clipper from household outlet.
3. Remove the blades and four screws
1
4. Lift off outer housing .
3
5. Remove the lithium‑polymer battery
2
1
WARNING
– Do not attempt to replace the battery
pack for the purpose of reusing the clipper. This could result
in the risk of fire or electric shock.
Parts
Replacement parts are available through www.babylissus.com or
by calling 1‑800‑326‑6247.
.
2
.
4
3
4
13