Troubleshooting - GiBiDi F4 Plus Manual Tecnico

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
PROFESSIONAL AUTOMATIC SYSTEM FOR GATES AND GARAGE DOORS

Troubleshooting

Before any installation or maintenance operation, ensure that the power supply has been disconnected.!!
FAULT
Red 24 Vac LED off
The operator does not open or reclose
The flashlight is on but the gate does
not move.
Red LEDs
FA1-FC1-FA2-FC2-PHOTOCELL off
Red STOP LED of f
Yellow LEDs always on
After the run time the gate does not
reclose
After the motors have stopped,
the flashlight connected to terminals
7-8 does not go off.
When the 2nd key of the remote
control is pressed, the pedestrian
gate is not activated
The gate does not perform a phase
shift when it starts
The transmitter has a small range
The card does not learn the TX code
When key 2 of the TX is pressed,
both yellow LEDs come on
(START and PEDESTRIAN GATE)
Warnings
While wiring or inserting the RADIO MODULE, the control unit must not be powered.
Use of this control unit must rigorously conform to the reference technical regulations.
Installation and/or maintenance must be carried out only by qualified personnel in observance of the legislative provisions in force.
The manufacturer cannot be held responsible for any damage caused by improper and/or irrational use .
GiBiDi declines all responsibility for any inaccuracies contained in this manual and re s e rves the right to make modifications without prior notice.
POSSIBLE CAUSES and SOLUTIONS
Check the 230 Vac power supply and the relevant fuse F1(5A)
Check that the red LEDs are on (except the LED of the limit switch active at that moment) and
the yellow ones off.
Start has been pressed with the photocells engaged. Check that the photocells
are not engaged; once released the gate will start moving.
Check that the relevant inputs and safety switches are connected
(FA1-FC1-FA2-FC2-PHOTOCELL) or the relevant DIP SWITCH set to ON.
Check the fuse F2 (0.16A).
Check that the STOP input is connected to an NC button or that a jumper has been connected
between the terminals 23 and 25 (WARNING: the STOP intervention causes a functional stop
and NOT a safety stop).
Check that the START and PEDESTRIAN GATE inputs have been connected to NO buttons.
Check that the trimmer V4 (Pause) is not turned completely anticlockwise.
Check that DIP9 is set to ON
If only 2 limit switches are used, the relevant DIP SWITCHES must set to OFF, the other 2 to ON.
Check that DIP10 is set to ON
Check that the trimmer V3 (closing delay) is not turned completely anticlockwise.
Check that the antenna has been positioned properly (braid terminal 26, core terminal 27,if a
built-in radio or AU01630N receiver is used) (if an AU01710 plug-in receiver is used, the antenna
must be connected to the terminals on the receiver).
Check that there are no sources of disturbances in the vicinity which limit the range.
Check the maximum number of codes that can be stored (200).
Check if remote controls of the same family as the first are being learned: DIP SWITCH or ROLLING.
Check that the frequency of the radio control is the same as the receiver.
The remote control has been learned by pressing the 2nd key and hence both the 1st channel
and the 2nd channel are controlled by key 2. Reset the memory and relearn the transmitters.
English
9

Publicidad

Tabla de contenido
loading

Tabla de contenido