Stobag SKIMY SRCU 80M Instrucciones Y Advertencias Para La Instalación Y El Uso página 63

03. At this point, read the section referring
to the "transmitter memorisation pro-
cedure" in the Receiver Instruction
Manual of the automation (the instruc-
tion manuals produced by STOBAG
are also available on the website:
www.stobag.com).
04. Then perform this procedure, taking
into account that:
Note: Each Receiver model uses a spe-
cific memorisation procedure, which
normally requires activation of a number
of keys on the transmitter, including: ▲,
■, ▼.
The entire memorisation procedure des-
cribed in points 01, 02, 03 and 04, must
be repeated for each of your Receivers.
— Step 4 —
CHECKING CORRECT MEMORISA-
TION OF TRANSMITTER
In this step, a number of tests must be
performed to verify correct memorisation
of the transmitter's "identity code" in each
of the Receivers present.
For this, refer to the section DAILY USE OF
THE TRANSMITTER (in this manual), and
proceed systematically to send a move-
ment command to each of the automa-
tions memorised.
— Step 5 —
PROVIDING THE END USER WITH
INFORMATION ON OPERATION
Important! - At the end of installation and
operational checks, compile the "OPERA-
TION TABLE", on the last page of this man-
ual. On this page, write the names of all
Single Automations installed and their ref-
erence Number (see your "Automation
List"). Also indicate the automation Groups
(only if already created) and their reference
Number (see the section below for the
Group programming procedure).
Lastly, to facilitate the task of future users
of the transmitter, ensure that the end user
is provided with the "OPERATION TABLE"
and this manual.
DELETING DATA FROM THE
TRANSMITTER MEMORY
All data can be deleted from the transmit-
ter memory as follows:
Caution: - This procedure definitively
removes all data and restores the origi-
nal factory settings.
01. With the transmitter switched off,
press and hold the key OK for approx.
25 seconds, until all symbols and texts
appear on display, then release the
key.
02. The display then shows the text "F..."
(indicating the version of the software
installed in the transmitter) and then
"P1" in rapid succession.
EN
63