Peavey IMPULSE 500P SUB Guía De Operación página 11

Tabla de contenido

Publicidad

Enclosure:
Peavey Impulse
®
500P Subwoofer (domestic)
Frequency Response:
45 Hz to 150 Hz
Low Frequency Limit (-3 dB point):
45 Hz
Useable Low Frequency Limit (-10 dB point):
36 Hz
Internal Power Amplifiers (@120 VAC line):
600 watts peak dynamic power, 300 watts continuous
RMS at clipping
Nominal Sensitivity (2.83V @ 1M, swept sine input
in anechoic environment):
98 dB
Maximum Sound Pressure Level:
124 dB music peak
Transducer Compliment:
Model 1568 15" Black Widow
Box Tuning Frequency (Fbox):
44 Hz
Electrical Crossover Frequency (High Pass
Output):
150 Hz
Crossover Type:
Internal electronic two-way crossover with active bass
boost and subsonic filtering
Crossover Slopes:
18 dB/octave (3rd order) low pass, 18 dB/octave (3rd
order) high pass, staggered poles
Electronic Input Impedance (Nominal):
Greater than 50 kohms, balanced or unbalanced
Input Connections:
One combo female XLR/ 1/4" phone jack and one male
XLR and one 1/4" phone jack connector all providing
balanced operation, in parallel
IMPULSE
®
500P SUB SPECIFICATIONS
®
weather-resistant woofer
Subject to change without notice.
Enclosure Materials and Finish:
Injection-molded high-impact polypropylene of a nominal
thickness of 1/4" and with textured finish, having a UL
flame-rating
Mounting:
Stand mounting on 1 3/8" diameter stands via molded-in
mount, flying via Peavey Versamount
of cabinet) and four rubber feet for floor use
Dimensions:
28.562" (72.55 cm) tall by 21.312" (54.13 cm) wide
(11.5" {29.21 cm} wide in rear) by 17" (43.18 cm) deep
Optional Accessories:
Impulse
®
500 Stacking Adapter
Impulse
®
500 Array Bracket
Net Weight:
62 lbs.
Shipping Weight:
72 lbs.
Additional Remarks:
Also available as a passive unit Impulse
4 ohm
AMPLIFIER SPECIFICATIONS
Nominal Amplifier Frequency Response:
+0, -1 dB 10 Hz to 30 kHz
THD and IM:
Typically less than 0.2 %
Damping Factor:
Greater than 100 @ 1000 Hz, 8 ohms
Hum and Noise:
Greater than 95 dB below rated power
DDT Dynamic Range:
Greater than 26 dB
Power requirements of Impulse
System (domestic):
500 watts, 120VAC,
60 Hz
11
70 (top or bottom
®
500 Subwoofer,
®
500P Subwoofer

Publicidad

Tabla de contenido
loading

Tabla de contenido