Technical Data - jbc Pulsmatic 55N Instrucciones De Funcionamiento

We would like to thank you for the trust you have shown in JBC in acquiring our soldering iron with its
solder feed system. It has been made to the highest quality standards to provide you with the best service.
Before using this equipment, we recommend you read these instructions carefully.

TECHNICAL DATA

55 N 230V Ref. 2552016
- Power supply: 230 V
- Power: 30 W
- Maximum temperature: 410°C
- Time to reach 250°C: 2 min.
Includes the following:
- Long-life tip C20D Ref. 0550509
- Replacement reel
INSTRUCTIONS FOR USE
Check that the mains voltage is the same as
specified on the unit.
Do not plug in the soldering iron without a tip, as
this might damage the element.
To avoid incidents, the hot soldering iron should
be kept inside the TS 1200 holder stand (Ref.
0290120), which is available as an extra.
REPLACING THE REEL
The reel is pressed into the support arm, where
it is held in place.
To extract the reel, rest the shaft end on a
convenient surface and press down on the reel
until it gives in.
Before fitting a new reel, pull out the solder
remaining inside the guide tube.
The solder flux may cause clogging at the end of
the guide tube: clean when necessary.
To fit the new reel, position it in such a way that
the solder wire runs off at the bottom; insert the
end of the wire into its hole and feed it in until it
becomes engaged in the feed mechanism.
Always use solder wire of 1 mm in diameter.
SOLDER REEL TYPES
Solder reel with ø1mm solder wire.
Alloy: 99%Sn / 0.3%Ag / 0.7%Cu - 50gr.
Green solder reel. SN5450
ENGLISH
3