jbc Pulsmatic 55N Instrucciones De Funcionamiento página 4

ENGLISH
SOLDER REEL HOLDER
For production-line purposes we recommend
using our holder BE-SA, which enables solder
reels in sizes up to 2.5 kg to be used. Simply
wrap a couple of turns of the solder wire around
an empty reel as shown.
BE-SA
TIP CARE
- Unplug the soldering iron.
- To clean the tips, use the damp sponge included
with the JBC stand. Only deionised water (car
battery watter) should be used in order to wet the
sponge. If normal water was to be used, it is very
likely that the tip will become dirty due to the salts
dissolved within the water.
- Do not file the tips or use abrasive tools which
may damage the tip's protective surface coating
and avoid knocking them about.
- If the tip has been a long time without being tinned,
use the metal brush Ref. 0297705 adaptable to the
support, to remove any dirt and oxide.
4
REPLACING THE TIP
Use the tip extractor Ref.0114108, and proceed
as shown in these diagrams.
1 Remove the ring to disengage the tip.
2 Remove the tip by pulling the soldering iron
backwards.
3 Insert the new tip and make sure it has gone all
the way in.
JBC reserves the right to make technical changes without
prior notification.