Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HANDHELD
CONFIGURATION
HANDHELD CODING PROCEDURE:
1. Disconnect the power supply to the stove.
OK
2. Press keys
and
OK
3. Using keys
and
4. Power the stove. Con rm the selected unit within 10 seconds (all LEDs ash on the radio/emergency card) by pressing the OK key on
the handheld.
5. All LEDs on the radio/emergency card will remain on for 2 seconds to con rm the new con guration.
6. If the con guration was unsuccessful, the display will read "APPLIANCE NOT FOUND". In this case, repeat the procedure.
OK
THE HANDHELD IS ALREADY CONFIGURED WITH "UNIT 0", IN THE EVENT THERE IS ANOTHER STOVE. TO AVOID
INTERFERENCES, A NEW CONFIGURATION MUST BE PERFORMED, MODIFYING ONE OF THE TWO STOVES.
SOME RADIO FREQUENCY DEVICES E.G. MOBILE PHONES, ETC... MAY CAUSE INTERFERENCE WITH
COMMUNICATION BETWEEN THE HANDHELD AND THE STOVE.
HANDHELD AMBIENT PROBE CALIBRATION
This mode allows to calibrate the ambient temperature detected by the handheld (only with ventilation activated). For correct calibration, it is
advisable to place the handheld in an environment with a constant temperature and to wait at least a couple of hours.
The procedure for calibration is the following:
Š Access the menu and reach "TECHNICAL MENU".
Š Set the access key "F4". - "ADJ REMOTE PROBE"
Š Using the keys
or
Š Save and exit with the key
BATTERY TYPE AND REPLACEMENT
To insert/replace the batteries, su ce it to remove the battery
protection cover at the back of the handheld ( gure 1).
Insert the batteries in accordance with the symbols imprinted on
the handheld and on the battery itself.
Three AAA batteries are required for the handheld to function.
Respect the environment!
Used batteries contain metals that are harmful to the environment, and therefore must be disposed of separately in
special containers.
at the same time until the UNIT selection screen appears.
select the new UNIT.
adjust the desired ambient calibration.
.
OK
OK
( gure 1)
ENGLISH
67
Publicidad
Tabla de contenido
