Positioning The Oven; Fixing The Hob; Connecting The Gas - Teka SL P60 4G AI AL Instrucciones Para La Instalación Y Recomendaciones De Uso Y Mantenimiento

EN
Installation
The glues used when manufacturing the
kitchen unit, and in the adhesive on the
decorative laminate
worktop's surface, should be made to tolerate
tempe-ratures of up to 100ºC.

Positioning the oven

See the corresponding manual.

Fixing the hob

Overturn the hot plate and correctly position seal
"J" under the edge of the hot plate itself, so that
the outer side of the seal perfectly matches the
outer edge of the hot plate. The ends of the strips
must fit together without overlapping.
Evenly and securely fix the seal to the hot plate,
pressing into place with the fingers and remove
the strip of protective paper from the seal and set
the plate into the hole made in the cabinet.
Insert the clips "S" into the slits "H" located in the
lower part of the body. Then apply the screws "F"
and tighten.
Clips and Screws are inside the bag supplied with
the product.
37
that is part of

Connecting the gas

the
Connecting the hob to the gas mains should be
done in compliance with the current installation
standards and regulations.
Ventilation slots should also be made at the site in
compliance with current norms.
The hob is provided with a threaded connection
1/2" in diameter, in line with EN ISO 228-1. A Ø
10/12 mm. copper pipe is provided as an
accessory for welding the gas inlet pipe.
Whenever the gas connection nut is removed, its
washer should be changed.
In order that the hob is not damaged by tightening
the nut on the gas connection pipe, a maximum
torque of 300 cm * Kgf should be applied.
When the gas connection has been made, the
installation should be checked to ensure that it is
completely sealed. If the check is done using air,
care should be taken that the test pressure is no
more than 200 g/cm2. Where air is not available,
soapy water should be applied to ensure that there
are no leaks in the connections. Testing should
never be done using a flame.
When the hob has been installed, check that the
burner minimums are properly adjusted. To do
this, light the burners and check that they do not
go out if you switch quickly from the maximum to
the minimum.