Technical Specifications - Paradox Magellan MG-PMD85 Guia De Instalacion

alarm signals for approximately 3 minutes. Due
to the motion detector's Alive software, the red
LED continues to flash to indicate a detection
even when in Energy Save mode. Once the
three-minute Energy Save mode ends, the
detector will return to normal operation.
If the detector's cover is removed and then
replaced while in Energy Save mode, the first
detection will trigger an alarm signal.

Technical Specifications

Sensor type:
Sensor geometry:
Coverage:
Installation height:
Operating temperature: -35°C to +50°C (-31°F to +122°F)
Animal immunity:
Power:
RF frequency:
Lens:
Transmitter range:
Tamper switch:
Detection speed:
†
Battery life :
* FCC ID: KDYMGPMD85
The MG-PMD85 complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
** 868MHz (only)
RTT&E directives.
Reference & Installation Manual
http://www.bakonline.net/
Dual Element Infrared (x 2)
Rectangular
11m x 11m (35ft x 35ft) 90°
viewing angle
2m to 2.7m (7ft to 9ft)
40kg (90lbs)
3 x "AA" alkaline batteries
433* or 868**MHz
2nd generation Fresnel lens,
LODIFF®, segments
35m (115ft) with MG-6060; 70m
(230ft) with MG-RCV3; typical in a
residential environment
Yes
0.2m/s - 3.5m/s (0.6ft/s - 11.5ft/s)
4 years
Canada: 2438A-MGPMD85
compliant to all EU and EFTA countries except Greece according to
7n