Faber CYLINDRA ISOLA Manual De Instrucciones página 10

PREPARATION OF THE FRAME FOR THE HOOD IN
RECYCLING VERSION
In case the hood is used in recycling version it is
necessary to prepare the frame with all the
necessary connection pieces. In order to make the
installation easier it is necessary to lengthen the
frame:
• Unscrew the two screws 2.1 fixing the upper
chimney to the frame and pull the chimney out.
• Unscrew the four safety screws placed at the top
in the frame separation area. (A).
• Unscrew the eight metric screws connecting the
two columns, placed on both sides of the frame
(B).
Installation of components in recycling version:
• Fix the recycling air outlet piece 15 to the upper
part of the frame using four 12c screws supplied
with the hood.
• Fix the flange (ø120) 10 to the lower part of the
recycling air outlet 15.
• Put the reducer flange 9 on the hood body outlet.
• At this point, join the flanges with a pipe. In
order to calculate the height of the pipe it is
necessary to estimate the height of the hood
(mm) and subtract 615 mm. (H pipe = H hood-
615).
• Lengthen the frame so that the pipe can be
inserted. Place the pipe between the two flanges
and block it. Make sure that the height of the
frame is correct considering the height of the
cooker hood (H frame = H hood – 184). Adjust
the height of the frame and tighten again the
earlier removed screws. Tighten again the safety
screws in order to give more stability to the
structure.
• Fix the pipe with the pipe clamps 25.
EN
A
B
12c
15
10
1
10