Loading And Unloading Discs; Switching The Source; Adjusting The Volume - Alpine PKG-RSE3DVD Manual De Operación

Ocultar thumbs Ver también para PKG-RSE3DVD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Loading and Unloading Discs

Turn on the power before loading and unloading discs.
Loading discs
1
Insert the disc with the label side facing upwards.
2
Once the disc is partially inserted, it is drawn in
automatically. Playback starts.
• For two-sided DVDs, play one side of the disc to the end, then
unload the disc, turn it over and reload it to play the other side.
• If wrong disc, upside-down discs or dirty discs have been
inserted, "Bad Disc" is displayed. Press
Unloading discs
Press
.
Be sure to remove the disc.
• If the disc is not removed within a few moments, it will be
reloaded automatically.
• During ACC OFF or while the disc is being loaded ("LOADING"
is displayed), the disc will not be ejected even if you press
Muting the Audio
Front Control Keys
While the power is ON, press POWER (
the Mute function.
Press POWER (
) again to turn OFF the Mute
function.
Remote Control
Press MUTE to turn it ON and OFF.

Adjusting the Volume

Volume can be controlled from the headphone or your own radio
volume function.
1
Turn on POWER on the headphone.
2
Adjust the volume level by turning clockwise for
louder and counter-clockwise for lower on the
headphone.
• Refer to the "Wireless Headphones" section on page 6 for
additional information.
4
-EN

Switching the Source

Front Control Keys
1
2
Remote Control
Press DVD, AUX1 or AUX2 to change each source
directly.
and eject the disc.
Setting the Backlight Brightness
1
2
.
) to activate
DVD Control
Press SELECT (
) to display the Source Select
Menu.
Press SELECT (
) again to cycle through the
different sources.
DVD
• OSD (On Screen Display) will turn OFF automatically after 5
seconds without use.
• When the source is changed, the power is turned OFF or the ACC
is turned OFF , the device remembers the scene where the internal
DVD stopped and playback will resume from that point.
Press Dimmer (
) on the Front Control Keys,
the DIMM button on the remote control, or select
the Backlight tab in the Picture Settings Menu
(refer to Monitor Setup instructions page 5).
From the Picture Settings menu, press
cycle through High/Mid/Low.
HIGH
Dimmer
DVD
Wait 8 seconds until OSD disappears; the
adjustment will be saved automatically ( if
the brightness is adjusted directly using the
Dimmer (
) key on the Front Control Keys, the
OSD will disappear after 3 seconds)
Press the DVD button on the Front Control Keys to
access the DVD Control menu.
DVD CONTROL
TOP
MENU
MENU
DISPLAY
SUBTITLE
AUDIO
ANGLE
1
2
3
4
5
AUX1
AUX2
or
MID
LOW
ENT
Front Control Keys
CLEAR
REPEAT
ENTER
RETURN
6
7
8
9
0
DVD SETUP
to

Publicidad

Tabla de contenido
loading

Tabla de contenido