Klarfit Ultimate Gym 9000 Manual Del Usuario página 37

EN
3
Attach the Support Frame (6) and Rear Upright Frame (35) to the Base Frame (1), using four M10X70mm Hex Bolts (100), eight M10 Washers (112) and
four M10 Nylon Nuts (117).
Remove two M10X25mm Bolts (105) from two Weight Guide Tubes (4).
Attach the Upper Cross Beam (18) to the two Weight Guide Tubes (4), using two M10X25mm Bolts (105).
Attach the Upper Cross Beam (18) to the Support Frame (6) and Rear Upright Frame (35), using three M10X70mm Hex Bolts (100), six M10
Washers (112) and three M10 Nylon Nuts (117).
Attach the Resist Bar (7) to the Support Frame (6), using two M10X70mm Hex Bolts (100), four M10 Washers (112) and two M10 Nylon Nuts
(117).
37