4. Operation Function Instruction
!
INITIAL STATUS
If you turn on this monitor, it search cameras.
G
If all cameras weren't connected to monitor, this screen display channel 1.
G
@
SEQUENTIAL SWITCHING MODE
Please press AUTO button, the monitor goes to sequential switching mode and the yellow
G
LED lamp of AUTO button will on.
The sequential switcher built in the monitor allows each camera to show the pictures
G
sequentially.
If a camera is disconnected from the monitor, it will be skipped and the deep sounds.
G
If camera 2 and camera 4 are connected to monitor, this is switched on sequence of camera
G
2, camera 4.
If all cameras were disconnected to monitor in AUTO mode, monitor displays channel 1.
G
The switching time can be adjusted from 1 to10 seconds by using time button.
G
Initial dwell time is 2 seconds.
G
If you want manually select camera, please press camera select button.
G
#
ALARM FUNCTION
When the alarm is triggered, its signal goes to the monitor and the monitor shows the
G
triggered camera picture on the screen.
When two or more cameras are triggered at the same time, the monitor shows finally
G
triggered camera picture.
To reset alarm in case of alarm triggering, press TALK(A.RESET) key.
G
Once the alarm is released, the monitor goes back to the previous mode automatically.
G
If you make the alarm off in the VCR mode, the system doesn't go back to the VCR mode.
G
It goes back to more previous state than the VCR mode.
To disable the alarm completely(the alarm is not detected), set alarm lamp off by using
G
alarm button.
Alarm time is 12 seconds.
G
$
VCR MODE
To see the recorded picture, press the VCR key on the system
G
%
AUDIO SYSTEM
This monitor has two way audio system.
G
When a camera picture appears on the screen, you can hear the sound from the camera's
G
microphone though the speaker built in the monitor.
If you want to talk to camera 2, please select it and go on pressing TALK button and talk.
G
30