Attach The Roll Unit; Attach The Basket; Assemble The Stacker; Turn On The Printer - Canon imagePROGRAF TX-4000 Guía De Configuración

5
Affix the printer to the stand.
Remove the alignment rod.
Use an M4 Allen wrench to securely affix three M4 hex
screws each on the left and right from the bottom of the
supporting plate.
• The removed alignment rod will be used when attaching the
basket.
Important

Attach the Roll Unit

• When using the roll unit
-> Attach the roll unit to the stand by referring to the
• When not using the roll unit

"Attach the Basket"

-> Proceed to
Attach the Basket
• When using the basket included with the stand
-> Attach the basket to the stand by referring to the
"Attach the Basket"
Proceed to
• When not using the basket

"Assemble the Stacker"

-> Proceed to
Assemble the Stacker
• When using the stacker
-> Assemble the stacker by referring to the
• When not using the stacker

"Turn On the Printer"

-> Proceed to
Turn On the Printer
1
Open the top cover.
Roll Unit Setup Guide (separate manual)
.
Printer Stand Setup Guide (separate manual)
.
.
Stacker Setup Guide (separate manual)
.
.
.
.
2
Pull up and remove the belt stopper (A).
• Keep the belt stopper you removed for future use. You
will need them in case you move the printer to another
Note
location.
• When you open the top cover, a cleaning brush is
stored on the right side. Take it out and use it when
cleaning inside the top cover.
5
A