Operating; Vacuum Cleaning - Fakir A 220 Instrucciones De Uso

en

Vacuum cleaning

A
C
12

OPERATING

Always check the appliance and the power cable before use.
Faulty appliances may cause injury and should not be used.
1. Attach the required nozzle.
2. Pull out the power supply cable " [A] " by tugging on the
plug until the required length is reached.
A yellow mark on the cable shows you that the maximum
cable length has almost been reached. The maximum
cable length is shown by a red mark on the cable. Never
pull the cable out of the appliance beyond the red mark.
3. To switch the vacuum cleaner on, the ON-OFF pedal but-
ton " [B] "
4. Set the required suction level using the suction power
regulator " [C] "
B

In case of full dust bag, as well as with clogged up accesso-
ries (hose, tube, nozzles), the filter exchange indicator
" [D] " lights up. In order to make an accurate evaluation,
D
press press the switch on the maximum vacuum power po-
sition " [C] " and lift the floor suction nozzle from the floor. In
this case, replace the dust bag and/or the clogged filters or
remove the stoppage.
WARNING!
NOTICE!