Led Indicators; Resetting To The Factory Default Settings - Axis Q1602 Guia De Instalacion

AXIS Q1602/Q1604 Network Camera Installation Guide

LED indicators

LED Color
Network Green
Amber
Unlit
Status Green
Amber
Red
Power Green
Amber
Status LED when using the Focus Assistant
Status LED Color
Green
Amber
Red

Resetting to the factory default settings

This will reset all parameters, including the IP address and focus position, to the factory default
settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the control button pressed for about 15–30 seconds until the status LED indicator
flashes amber.
4. Release the Control button. When the Status indicator displays green (which can take up to 1
minute) the process is complete and the network camera has been reset.
5. Re-assign the IP address, using one of the methods described in this document.
6. Refocus the camera, using one of the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web interface.
For more information, please see the online help or the User's Manual.
Indication
Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Steady for connection to 10 Mbit/s network. Flashes for network activity.
No network connection.
Steady green for normal operation.
Note: The Status LED can be configured to be unlit during normal operation, or to
flash only when the camera is accessed. To configure, go to Setup > System
Options > LED settings. See the online help files for more information.
Steady during startup, during reset to factory default or when restoring settings.
Slow flash for failed upgrade.
Normal operation.
Flashes green/amber during firmware upgrade.
Indication
Step 4: Focus Assistant is enabled
Step 6: The lens is optimally adjusted
Step 4: The camera has been moved, or an object has been inserted in front of
the lens. Exit and restart the Focus Assistant.
Step 6: The lens is less optimally adjusted
Step 4: The camera has been moved, or an object has been inserted in front of
the lens. Exit and restart the Focus Assistant.
Step 6: The lens is poorly adjusted
Page 19