Adjusting The Cut Position - Dascom Tally T2380 Guia De Instalacion

Quick start guide Control panel operation

Adjusting the cut position

The cut device will always cut the fanfold paper at the same set position. As a rule
this position should be just below the perforation of the fanfold paper.
Do not cut the paper above the perforation as the optimal paper flow may be
STOP
adversely affected by the paper remaining above the perforation.
Before setting the cut position, fanfold paper must be loaded and the printer set to
Online.
Proceed as follows to set the cut position:
Press the Setup button...
...and then choose the parameter Adjust (2).
Now press the Cut (4) button.
The printer switches to the precise cut position adjustment mode.
Please note that an automatical form feed is performed before each adjusting cut.
When the < (2) or > (3) buttons are pressed briefly, the paper is either moved for-
ward or backward. The individual values are displayed in increments of 1/72 of an
inch. The possible adjustment range is from -20/72" to +20/72".
15