Additional Programming Sequence - Dascom Tally T2380 Guia De Instalacion

Quick start guide

Additional programming sequence

In addition to the MTPL programming sequences described in the optional Pro-
gramming Manual (ID: 379 298), the sequence for cutting at the current line is
available.
Data structure
ASCII ESC ,,[" < n >
hex. 1B 5B n
dec. 27 91 n
Parameters
For the ESC [ n { sequence the following parameters are available for n:
n hex. dec. paper feed and cutting
0 30 48 single sheet (manual)
5 35 53 fanfold paper tractor 1 (front, standard)
6 36 54 fanfold paper tractor 2 (front, option)
7 37 55 fanfold paper rear tractor
50 35 30 53 48 reposition at print position
51 35 31 53 49 cut fanfold paper at the next perforation
54 35 34 53 52 cut is made above/below the current line
1) above the line, the text to be printed was ended with a CR (hex.0D, dec. 13)
below the line, if the text to be printed was ended with a LF (hex.0A, dec.10)
Sequences for selecting the automatic single sheet feeder (ASF) are ignored. The
cutting of single sheets is not possible.
For further explanations regarding the available programming sequences please
refer to the Programming Manual, available at your dealer and on our internet site.
Additional programming sequence
,,{"
7B
123
1)
23