Operation; Reset Button; Emergency Stop - LGB MZS Zentrale III Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20

Operation

Reset Button

When you press the "Reset" button, the central unit goes
back to its starting point again. To do this hold the "Reset"
button down at least one second. All of the locomotives will
comes to a stop.
All of the data stored in the central unit (example: locomo-
tive speed, lights, smoke on/off ...) is deleted. A locomotive
address must be selected with an entry device in order to
get a locomotive running again. Set the speed to "0". Then
start the locomotive running again.
10

Emergency Stop

MTS hand controllers are equipped with an emergency stop
button in order to prevent accidents. This button is marked
"STOP". When the emergency stop button is pressed, the
central unit shuts off the track current immediately. All of the
locomotives come to a stop. All of the data remains stored in
the central unit.
If two locomotives were on a collision course before
the emergency button was pressed, the speed for these
locomotives should be set to "0" with the MTS locomo-
tive controller during the emergency stop. After about 3
seconds, the emergency stop can be turned off by pressing
the emergency stop button again on an entry device. Then,
the locomotives will run again with the speed previously set
for them.
Or, press the "Reset" button on the central unit. Then, all
of the locomotives will remain standing at a halt after the
layout has been turned back on.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

55006

Tabla de contenido