Cleaning Hard Floors - Hoover SteamVac Dual V F7412-900 Manual Del Propietário

Cleaning hard floors
How to attach bare floor tool
(Available at additiona] cost if not included
with your cleaner.)
Unplug cleaner from electrical outlet.
To prevent possible leaking, remove clean
water tank
(Fig. 2-12}
and recovery tank. Set
tanks aside (do not set tank on furniture}.
1. With handle in upright position, tilt
cleaner back so that handle rests on the
floor.
2. With foam strip (A) located under the
netting} in position as shown, place attach-
ment on front of nozzle (B).
Make sure arrow on end of attachment
points in the direction as shown.
3. Push attachment against nozzle while
rotating attachment downward until both
ends snap into place.
Note: some force may be required to rotate
and snap attachment into place.
4. Return carpet cleaner to upright position.
Lower handle and replace recovery tank.
5. Raise handle to upright position and
reposition clean water tank.
To clean hard floor
Read "Before you begin cleaning" instruc-
tions on page 13.
Do not use the carpet cleaner on unsealed
hardwood floors.
CAUTION: To prevent damage to wood floors,
follow the flooring manufacturer's cleaning
recommendations.
If using cleaner on sealed wood floors,
inspect floor surface for worn finish, bare
wood or separated joints. It is not recom-
mended to use the cleaner on wood floors if
any of these conditions exist.
1. Fill clean water tank according to instruc-
tions for Figs. 2-9 to 2-10.
2, Fill detergent container with HOOVER
Hard Floor Cleaner according to Bare Floor
Cleaner instructions for Fig. 2-11.
3. Slide brush setting selector to Gentle
Scrub or Off.
4. Dry hands and plug cleaner into a proper-
ly grounded outlet.
15
5. Step on handle release pedal and lower
handle to operating position.
6. Set Wash/Rinse (Auto-Rinse" optional}
switch to WASH. Turn cleaner on.
7. To release solution, press trigger.
Slowly
move cleaner forward and backward over
area to be cleaned.
8. To pick up dirty solution, release trigger
and slowly move cleaner over area where
solution has just been dispersed. Use both
forward and reverse strokes.
9. If rinsing the floor is desired, set Rinse
Setting switch to RINSE. Repeat steps 7 Et 8.
This setting provides a water-only rinse in
both the forward and reverse strokes.
Rinsing is not necessary, but will help
remove detergent residue from the floor.
10. Empty recovery tank when the motor
sound becomes higher pitched and there is a
loss in suction (see "Automatic shut-off",
Fig. 2.18).
(Continued on next page}
www.hoover.com