Ecoflam MAX GAS 350 P Manual De Instrucciones página 19

Red blink code of
signal lamp (LED))
2 blinks
3 blinks
4 blinks
5 blinks
6 blinks
7 blinks
8 blinks
9 blinks
10 blinks
14 blinks
A
To adjust air flow, turn the screw A as required. To reduce output, turn screw clockwise, to increase it turn screw coun-
terclockwise. Note: screw B not used.
Error code table
«AL» at Possible cause
term. 10
on No establishment of flame at the end of «TSA»
- Faulty or soiled fuel valves - Faulty or soiled flame detector
- Poor adjustment of burner, no fuel - Faulty ignition equipment
on «LP» faulty
- Loss of air pressure signal after «t10», - «LP» welded in normal position
on Extraneous light when burner is started up
on Time out «LP»
- «LP» welded in working position
on Free
on Too many losses of flame during operation
(limitation of the number of repetitions)- Faulty or soiled fuel valves.
- Faulty or soiled flame detector - Poor adjustment of burner.
on Free
on Free
off Wiring error or internal error, output contacts, other faults.
on CPI contact not closed
FIRING HEAD AND AIR SETTING
2
B
2
D E T A L I
420010563501 Max Gas 350 - 500 P/P AB
1
VERSION P
19
1
D E T A L I
EN