Pairing A Bluetooth Device; Connecting Two Speakers - ION Pro Glow 150 Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Pro Glow 1500.
3. Use the Mode button to select Bluetooth mode, which appears as "bt" in the display. Pro Glow
1500 will automatically go into pairing mode to search for Bluetooth devices. You will know you
are in pairing mode when the Bluetooth icon is flashing.
4. Navigate to your Bluetooth device's setup screen, find Pro Glow 1500, and connect. The
Bluetooth icon will remain solidly lit.
Note: Users should consider updating their device's OS if experiencing trouble with pairing or
playing music.
5. To disconnect pairing, turn off Bluetooth on your device or select Forget this device from your
device.
Note: Press and hold the Play/Pause button for 6 seconds (the display will show U-OFF) to disable
the Bluetooth pairing voice prompts. Press and hold the Play/Pause button again for 6 seconds (the
display will show U-ON) to enable voice prompts.

Connecting Two Speakers

To link two Pro Glow 1500 speakers:
1. Plug a XLR cable into the Mix Output located on the rear panel of one Pro Glow 1500.
2. Plug the other end of the XLR cable into the XLR input of another Pro Glow 1500.
3. Power on both speakers. Use the Aux Input Volume on the second speaker to adjust the input
signal level.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido