STARFRIT 093209 Instrucciones Y Recetas página 6

TO USE
(Read the instructions before first use)
NOTE: T he appliance can operates with a 6V adaptor (included) or with 4 AA batteries
(not included)
WARNING: Cutter blade and holder spike are sharp, you must handle with care.
Never touch with bare hands.
1. Center the food on the bottom food holder and press gently.
2. Lower the upper food holder so that it grasps the food and holds it securely.
3. Using the height adjustment level, raise the cutter arm so that it rests on top of food
to be peeled.
WARNING: Do not grab cutter blade as it is razor sharp!
Turn ON the appliance by pressing on the red button. The skin peels off in one clean,
4.
continuous curl.
NOTE: The appliance will stop automatically when the cutter arm reaches the bottom.
5. Lift upper food holder from food and raise it to the top of the support column.
6. Grasp food and using a gentle back and forth rocking motion, remove food from bottom
food holder pulling towards you.
NOTE: Do not yank the food straight up from the bottom food holder as the holder spike is sharp.
WARNING: Always turn OFF the appliance before removing/placing food on the food
holder
7. Trim off any deep potato eyes with the little plastic knife, conveniently stored
underneath the unit FIG 2. Use the same knife to remove blemishes on fruits and
vegetables FIG 3.
FIG 3
HOW TO CHANGE THE BLADE
(Read the instructions before handling the blade)
NOTE: The blades are specially designed to give clean and easy peeling or cutting.
When the blade skips or jams, or is excessively clogged, it's time to change blades.
WARNING: Blade is razor sharp you must handle with care.
1. Turn the appliance upside down and open the battery compartment located underneath
the base. Remove the batteries (if installed) to reach the blade storage compartment and
open it. Remove one of the new blades.
NOTE: Disconnect the adaptor from the appliance and remove the batteries
(if installed) prior to changing accessories or touching the blade holder.
2. Remove the cutter head by gently pulling the lock-in attachment from the
cutter arm.
3. Unlatch and slide the used blade away from the blade holder. Dispose of the used blade
using the same precautions taken with a sharp razor.
4. Slide the new blade down the ridge of the blade holder.
NOTE: Make sure the blade is solidly in place before proceeding to the next step.
5. Put the cutter head back on the appliance by inserting the lock- in attachment into the cutter arm.
6